Monday, January 16, 2017

DIY 3D Printer Updated to a PRUSA I3 Compatible Version

I am working upgrading  my 3D printer to a PRUSA I3 Compatible Version.  I will also be updating my book "Inexpensive 3D Printer Projects" once the upgrade is completed and working.  Hopefully there will also be a all metal version of the PRUSA i3 3D printer in that book as well.

One of the issues so far is that the PRUSA i3 uses a 5 mm threaded rods for its lead-screws.  I wish that there was a 8 mm compatible version available.  I have found a alternate X axis end design that I can print out that does support 8 mm lead-screws.  Here is a link to the upgrade: http://www.thingiverse.com/thing:1140733. The other option is to purchase the all metal X axis for the Geeetech i3 printer.  I am also making a normal PRUSA i3 printer to verify that all of the parts are interchangeable with my design.

This is what the rebuilt 3D printer looks like so far:

Here is a progress report picture on rebuilding the 3D printer.

It now has the Y platform installed and the Arduino is in place as well.

This picture shows the wiring (mess).


Here is the results of the first test run.  The X axis belt skipped and caused it to print in the air after a few passes.

There were some more failures before I changed the extruder and fixed a wiring problem.

After a couple of calibrations it is now working.


This is what the finished elephant looks like.  My Z axis was off (3333 vs 4000) so it is shorter that it should have been.

To verify compatibility I am also building a PRUSA i3.  Here is the frame with the printed parts.

Then I switched to my home made metal parts.  I need to cut the Z axis shafts off so they are shorter.

I spray painted the frame with about 4 coats of gloss black paint.  It looks a lot better now.

I have added a Geeetech i3 all metal X axis to the Prusa i3 frame!  The secret is the home made motor mounts.
This is what the completed GeeeTech i3 all metal 3D printer on a PRUSA frame looks like.
This is the electronics for that 3D printer.

No comments: