Saturday, March 7, 2009

Hp Laptop Motherboards

Is it just me or are there a lot of HP motherboards with a broken power jack? Replacing the jack will not fix it as the board is damaged around the back, center connector.


The real solution is to run a 24 gage jumper wire from the shiny pad to the left just behind the power jack and just in front of the modem plug to the center connector of the power jack on the bottom side of the circuit board. That will replace the burned out traces on the top side of the circuit board. You might just be able to solder the jack on the top side if the run is not totally destroyed already. In most cases there is nothing left to solder it to on the top side of the board.

1 comment:

  1. There are quite a few like this, that need a jumper wire run once the jack breaks, good find! =)

    ReplyDelete