Building my own 3D printer part 3 and the first video

My 3D printer had its first test run last night.  So far I need to replace the X axis stepper motor it has a bad connection inside of it somewhere as can be seen in this video on Youtube.

http://youtu.be/s77h1BQ-EVQ

Here is a picture of the jumpers to convert the Ramps board to a printer 25 pin interface.  I only connected to the pins that I needed for X, Y, and Z for Step, Direction and Enable, they are blue, green and yellow.  The enables are all connected to ground.  Then I also needed to connect to ground and 5 Volts, they are yellow and red, the top two connections..

Here is another video of the DIY 3D printer this time it is running with and Arduino Mega.

http://youtu.be/YemKKhmJT2o

Here is a picture of the Ramps wiring.  The heat bed is not wired up yet.

Here is the wiring with the heat bed wires in.  I spliced the ribbon cable into some 14 gauge stranded cable and covered the splice with heat shrink.

Here is the third video.  This was my first extrusion attempt.

http://youtu.be/vYSjmuuCgkQ?list=UU49j5FVUO2KIFyH2IXmGXjg

Here is what I got from my first attempt at making something.  It was supposed to be a 8mm bearing support.