This picture shows the location of the zener in the schematic;
here is the location on the circuit board:
Thursday, July 7, 2011
QSC 1400 Amplifier repair
I recently purchased a non working QSC 1400 amplifier. A few seconds after being powered on the clipping light comes on. I downloaded the schematic and started checking voltages. The +15 and -15 volt power in one channel measured at pins 4 and 8 of the op amp was only +9 and -15 volts. I traced out the power and found +9 at one end and 0 volts at the other end of a 3.9 volt zener diode.
This picture shows the location of the zener in the schematic;
here is the location on the circuit board:
This picture shows the location of the zener in the schematic;
here is the location on the circuit board:
Subscribe to:
Post Comments (Atom)
3 comments:
Hmmm.. the schematic and the actual board seems to have a mismatch. Better check with your supplier on that one.
double glazed windows
It’s actually a nice and helpful piece of info. I am glad that you shared this helpful info with all of us. Please keep us up to date like this. Thanks for sharing.
QSC
im searching of qsc gxd 8 service manual and in that especially zener diode (Z6) located beside IR2110S igbt switching ic .kindly help us on finding or sharing the service manual to dravreceiver@gmail.com
Post a Comment