Crown XTi 1000 power amplifier repair

Over the weekend I dissembled and repaired a Crown XTi-1000 amplifier.  The problem was caused by bad connections on a bridge rectifier located in the power supply section.

This is a close up of the bad connections.  The leads needed to be cleaned and re-soldered.

This is the corner of the board where the problem is found.

This is what the amplifier looks like with the cover removed.  You need to remove the front, then all the screws on the back, then all of the screws holding the board in place.  There are four screws holding the heat-sinks in place that are under the foam.